Want to get even more
Xtreme?
Check us out on:
Join our
Preferred
Customer Club
You will receive
information about
upcoming events, specials,
discounts, and more.
Xtreme Car & Truck
Accessories
150 Millers Run Road
Bridgeville, PA 15017
Phone: 412.257.1006
Fax: 412.257.2002 |
 |
 |
 |
 |
Remote
Starters
Viper Remote Start Keyless Entry
Model 5301 Addendum
© 2008 Directed
Electronics, Vista, CA
ADN4202 2008-06
The
following list addresses
errors/inconsistencies found in both
the 4202 Installation guide (N4202
2008-06) and Owner's guide. (G4202
2008-06):
Installation guide
| Page |
Description/error |
Correction |
|
inside cover |
Error is found in
the Bitwriter® chip version
requirement:
version 2.5 |
The Bitwriter (p/n
998U) requires
chip version 2.6
or newer to
program this
unit. |
|
56 |
Error is found
in Feature 3-15:
"temperature
auto report" |
This unit does
not have the
temperature auto
report feature.
|
|
59 |
Error is found
in the "To
activate
Valet-take over"
section; Step
#1: the (RS
icon) button. |
Before turning
the engine Off,
press and
release the
 button. |
| 61 |
Important
information was
left out of the
Timer Mode
explanation. |
The system must
be locked for
Timer Mode to
operate. |
Owner's guide
| Page |
Description/error |
Correction |
|
12 |
Error is found
in the Unlock
icon Command
text: "Press one
time to Lock" |
Press one time
Unlock |
|
25 |
Important
information was
left out of the
Timer Mode
explanation. |
The system must
be locked for
Timer Mode to
operate. |
|
27 |
Important
information was
left out of the
Smart start
activation
explanation.
|
Smart start uses
temperature and
voltage settings
to determine
when the vehicle
should start and
run. If any
changes to
temperature or
voltage are made
using the
Bitwriter
programming tool
Smart start
activation is
affected.
The Smart Start
function works
similar to the
Timer mode. The
system must be
in the locked
mode, and using
the system
default
settings, it has
a maximum of 6
starting cycles
and checks the
voltage/cabin
temperature
every 3 hours to
see if the
thresholds have
been met.
If thresholds
have been met
then the remote
start will start
the vehicle and
run for the pre
programmed time.
It counts the
first start as
one successful
start, leaving 5
start cycles. If
the threshold
has not been met
then the system
will not start
the vehicle, and
6 start cycles
are left. The
unit continues
to check
threshold levels
every 3 hours.
Note: Each
voltage and
cabin
temperature
setting can be
adjusted and
turned off using
the Bitwriter
programming
tool. |
|
|
|
 |
|
|
|